hi ted brakes are black max hydraulic rear wheels.was easy to install on my existing axles just had to get key slot cut to hold the calipers.if you have the narrow wheels you will...
...do a deep inspection of the moving bits (cables, brake lines, etc). I installed the wing only to look at fi...nd then put it back on my GTE. I still need to complete my inspection, install my radio, intercom and mount...
All of them has bigger cracks, I prefer to install them. Are these called grommet or protection cap? I saw the word "protection cap" in the rotax manu...
hi Rizzy, I Will not install Lynx or Commtronics, or Communica systems in any aircraft as I find them less than usless. The Flycom system works very well. I still don't use...
...t fine, however when I broke in the engine the water wouldn't go past 136!!! After it is flown for the first time, I'll decide if I need to install some sort of water valve so t...
Hi Sally,
LEAF (Leading Edge Airfoils) Supply catalog refers to these as cable grommets.
You need to remove the cable from the carb to install new ones. It's a simple p...
...quirement to have a backup fuel pump. I installed it for peace of mind in cas...t. Some peace of mind eh?
Henry - I installed directly in my main fuel li...ne in a parallel config, I'd need to also install one or two check valves depen...
...e! Thank you for posting this. I bet a few others wondering about this install will benefit as well. A movie.... I was initially thinking that I would need an additional strobe installed on my belly or up on the en...
...in person on one occasion, (Kens). I'm hoping to wrap up the GTE/Profi install and inspection on Sat and pos...flight. I'll most likely upgrade to the electric trim system that you installed Chris but that's later...
...completely redesigned my electrical system by adding the alternator and the fuse bus located on top of the fuel tank. I'm going to now install a relay between the battery a...