Results for "Bar clamp"
Comments
...spliting the "T" that goes over the basetube and welding some clamp bolts on it and then curving the D into an O back on itself. Is there rubber under the clamp on the basetube? Hm, do...- Got 2.5 hours in the air today, Had to tighten 1 hose clamp just a bit after the first hour, otherwise the beast ran perfect. I was only 1 up, but did some extended climbs at 5400...
- ...r than the deadest preacher! ) to counter the weight i mounted a HUGE c-clamp on the left side. (equal, and...ghed a paltry 2 pounds or so, so i could use a smaller (and lighter ) c-clamp, and could now see (more or l...
- The ones I'm building are similar. Instead they slide over the base tube and have a bicycle seat clamp on one end to hold in place (360 degrees movement). I opted...
- ...t lexan scrap as well using those luxurious Harbor-F benders. I bent a couple of flaps for the vise. Now if I have a sensitive item to clamp down on, it won't be marr...
- In wing down mode to check the mast welds out on my Tanarg. Found one MAJOR gig. Carb retention spring clamp on the cross manifold vacuum balance lines was pulled down into the carb...
Comment on "Secrets of Cost-Effective Maintenance and Recommended or Required: The Savvy Aviator #61 & #63 Mike Busch AvWeb"
...Aviation for an overhaul. They did a great job and I had no problems with them. When I reinstalled my carbs, I did not tighten the clamp on one of the coolant lines o...Comment on "Equipment for XC Flying in a Trike- Series of emails"
...opes (these are not tie-downs), baking soda / superglue / nail file / piece of emery paper (for prop-chip repair), zip-ties, rubber bands, 2 kelly clamp (long surgical needle-nose lo...