Results for "tube"

Comments

  • Comment on "Trike Maintenance"

    Comments didn't appear for some reason.  Fork tube can rotate slightly (1/8") in base tube (base tube is not bent and still in spec before I'm asked) - no hard landings from me - held by 2 AN bolts. Anyone dealt with this before?

  • Comment on "Carburetor Icing Probability Tool"

    ...sp;the factory setting, but there are next tubes with hot oil or water, next...er air intake" into the carb. It is a tube. One end of the tube goes to...ir reduces effect - power the carb) because the tube sucks hot and cold air both.&...

  • Comment on "Trike Maintenance"

    ...ck, this is elongation of the holes in the base tube through which the two bolts pass at 90 deg that secure the fork carrier tube to the base tube. Speaking wi...rder than normal!! So it is a replacement base tube that is required,with the ass...

  • Comment on "SP13"

    ...ber then you could machine a thread inside diameter to your  camera tube then a bolt with a large flat...sher through a hole in the rubber keel plug that screws into your camera tube. Then  you would just ha...

  • Comment on "The subject of grips"

    Ah I see, on my trike the 'base tube' isn't a tube - its a rectangular shape and @XCtriker 's trike doesn't even have one!

  • Comment on "airborne-3"

    The component appears to be the front base tube to front support tube junction where the forks bolt to the base frame? An important piece. All Trikers should be sure to read all the Airworth...

  • Comment on "bonners ferry fly in 2015"

    ...e it is due to the music. I have had that happen several times where You Tube actually muted the audio. My...e music I want, add just 5 or 10 seconds of video, then upload it to You Tube and see what restrictions pop...

  • Comment on "Did he remove the front tube prior to flight? :)"

    ...watch this video previously and I said to myself, "where the front tube went." After further exa...ticed that there wasn't one at all, it was just the left upright/downtube that looked like the front tu...

  • Comment on "The subject of grips"

    Ken,  I think when you say base tube, we call it a control bar.  We call base tubes the main tube in the base of the trike that runs bow to stern and takes the loads.  I think us ozzies understand you though :)

  • Comment on "Airborne Cracking Problem Identified."

    This may be a stupid question, but what is a prow tube /limiter tube?    Oops, maybe I should have posted a stupid question anonymously.  :-)