Results for "edges"
Comments
...sors, and used this tape called...."Tear-Aid" I think, and he lined the edges with the tape. No sewing. He did an awesome job...you can see the taped edges on the bottom right last pict...- ...ould work fine also. Carbon fiber vinyl will look nice- the edges might peel up though soon enough, so maybe put some coping around the edges. Or just get a sheet of...
Comment on "Virga: What is It, and When to Avoid (Pilots Tip of the Week)"
Viagra is up going, virga is down going. ;) Don't mix them up. IMHO: Light virga and light rain are not too bad for short distances- but some wings do not perform well at all with wet leading edges-- including dew on the wing in the am.Comment on "Strongest Wind you would comfortably fly in with NO Turbulence?"
...t pushed myself there yet. I plan on going up with an instructor soon. I just want the comfort to know I have an instructor and then find what the edges of my comfort zone really is....- ...se, you duck down a little more. Soon you find yourself too low to comfortably turn back, possibly trapped in a low narrow valley with vague edges and nowhere to escape. ...
- The gaskets are on the intake manifolds, not the heads. They are paper and sometimes a bit too large. Just sand them down on the inside edges until they are flush with the inside...
- I did it one handed with an unleashed iPhone and a little turbulence at the edges of the warm/cold zones San Luis Bay was a hole in the clouds, then miles of clouds to go over...
- ...kick it back in to the core nicely done. where there is strong up air in the core of the thermal rizzy there is down air on the edges . when you get on the edge&nb...
Comment on "When I learned my lesson about Dew Point-- TIWTIWGTD"
...e garage to get it off the car! And the last landing of my flying career was a down-winder at freeway speeds in lower Parma. Took out both leading edges and left me with internet pub...- ...ell before the Dawn, but was expensive to make. The ASG-23 had no crossbars, just a very large "super-noseplate" which the leading edges were plugged into, during set...