Results for "carb ice"
Comments
Peter, the carb sync changes with stretching of the throttle cabl...Rotax for the 100hourlies, and the thread on one carb throttle adjustment elbow had...previous owner had been adjusting them. Therefore carb syncing was necessary. Bu...- Hi CrayonBox, Don't play with your carb sync. The 912 carb are preset and should not be touched unless your engine...to me from the engine people Bert Floods. I have never touched the Carbies on any of my aircraft and...
- ...a genius....for us - poor pilots :) We use engines with outside carbs as VW, Subaru or mine Verner. Simple solution for us is "winter air intake" into the carb. It is a tube. One end o...
- ...idn't need the extra power.i stayed with single carb so I went from 40 hp to 48hp...urs so I bought all the gaskets for a top end decarbon at 150 but came across a 50...odel when production was stopped.has exaust and carb no box I used it on the 503
- ...should explain is my trike is 5 years old and i carried out the rubber replacement as recommended by Rotax, and replaced the carb diaphragms. Another reason to carry out carb adjustments. And to be...
- ...from a spring behind your throttle pedal that may not necessarily allow carb throttle arm to return to idl...at if there was tape or a zip tie on cable nut so that it is captured in carb throttle arm?
- ...rs to these as cable grommets. You need to remove the cable from the carb to install new ones. It's...wouldn't hurt to do so with the aid of someone who has taken a Bing carb apart before. Here is a l...
- ...down mode to check the mast welds out on my Tanarg. Found one MAJOR gig. Carb retention spring clamp on the cross manifold vacuum balance lines was pulled down into the carb heat fluid line, pierced it a...
Comment on "How many engine outs have you had? Rough engine precautionary landings do not count, unless the prop is gone, then count that as an engine out. Running out of gas counts too. After voting, confess your sins. Everyone should have a story to share."
...n the cold months. Now when I look back, there could have been a few reasons...1) Improper warm up of the engine 2) One of the carb was going bad, the brass arm in the carb was getting stuck 3) In one o...- ...er landing I checked float bowl , clean.I must assume that my macuni Carb may need altitude adjustment....e with only low hours on it. But these videos keep my mind focused. carb