Results for "Strobe Light installation on Wheel Spats"
Photos
In this photo, the wheel pant is upside down, and we are looking in to where the wheel would be. The rear of the wheel pant i...r where the axle of the trike wheel goes). I drilled a smal...he bolt and washer of the LED strobe itself. I cut the rubber slightly oval so that I'd have a tab...- I mounted the strobes slightly rearward of the fattest portion of the wheel pant. I didn't want the strobes to be the things that...rthest (in harm's way). In this position, the wheel pant angles slightly to the rear- so the light in this position has a slight...
- At the blue arrow, I attached a zip tie to an oval piece of rubber I cut. &...ce under the bolt and washer of the LED strobe itself. I cut the rubber slightly oval...hen exits toward the right out into the strobe near the second of the two strobe light...
- Routing the wire from the wheel pant to the wheel strut. The two blue arrows show: where a tension loop is placed and an electrical connector to allow disconnection in case the wheel pant needs to be completely removed where the strobe is on the outer aspect of the pant
- Because the Tanarg has a very wide stan...nclosed trailer will have the wheel wells inside the cargo space....ittle ramps to lift the front wheels up over the wheel wells so that that wheel pants (spats) didn't crunch into the w...sp; The ramps also acted as a wheel chock-- and the aluminum piec...
- Hi all, I'm finally adding my Aveo Powerburst Plus 3 in 1 Strobe, Nav and marker lights on my Tanarg. I'm adding them high up on the wheel fairing; the same place the Revo uses. This location...to mount the wires coming down the fin and around the wheel...
- This photo was taken one beautiful evening at California Valley at twilight. With one additional wire, the lights can be synced (right and left) so they fire at the same time. I used a dipole switch for my strobes (off, position, strobe) $27 from B & C Specialty Products.
- Mayby one wing, maybe another. So many decisions. Gotta connect the rear strobe light and paint the header pipe. The saddle bags will go on and the Ballistic Chute re-installed. This trikes looks and sits like a two place but it is a single.
- This is the Northwing Bracket specifically for BRS installation