Results for "mounting"
Photos
More mounting brackets and brainstorming. As I recall, this stuff hurt my head. I am allergic to numbers.- Outside view of the new mount. All sections are shorter and will have much less vibration. Used steel instead of aluminum in this mount
- Chose a new mounting location under the motor mount where there were pre-existing holes to take advantage of. Used steel angle iron to make the mount
- Side view of Strap routed behind the seats to the frame/engine mount. This configuration was recommended by John Dunham at second chance
- This is my trike pre test period. The Aerolux 72 did not work out due to the position of my engine mounting. It turned out with the wing on, the 72 inch reach was scary close...
- The engine install was the hardest part for me. Each measurement was crucial and there were no mounts in hand. Mounting hardware had to be made in the shop. My head pipe design was...
- ...ld put a hole through and zip tie to. The grey wire then exits toward the right out into the strobe near the second of the two strobe light mounting nuts. I put rubber unde...
- Hi all, I'm finally adding my Aveo Powerburst Plus 3 in 1 Strobe, Nav and marker lights on my Tanarg. I'm adding them high up on the wheel fairing; the same place the Re...