...ontinued north and crossed the Little Colorado River again. Here it is a very steep and narrow canyon. It definitely was a thrill t...ore than it would over the large Grand Canyon the next day.
We followed the Little Colo...
The slot canyon of the San Raphael River appeared a few miles further downstream. It is deep dark canyon with no escape.
We followed the slot to Mexican Mountain. I circled the mountain for fun, then came down to land.
...oking in to where the wheel would be. The rear of the wheel pant is toward the top. The outer side of the wheel p...re the axle of the trike wheel goes). I drilled a small hole there...tie to an oval piece of rubber I cut. The rubber is basically a was...
...Hombre, Jaguar, Nayarit Association Civil)
Her rescues Jaguars and promotes their survival locally. As a top predator, their sur...nd a healthy environment.
Virgilio Tamez -- I miss you man, I've tri...
...eading out an amazing hour long flight up the Green River. I landed first and followed Paul out of there. I wish I had my camera runni...e took off. I was pissed, but had to laugh out loud. It took a minute to disapate...
...l with bar out at 5500. Astronomical fuel burn.
Touch down speed 45kts...Roll handling is great! Pitch is quite stiff.
Does not handle turbulan...glider with bar stuffed is not valid. They are completely different! Fa...
...owned "as far as the eye could see." This Castle is truly pricele...was a movie about Hearst-- "Rosebud." Europe had been devastated b...n carvings, entire church ceilings, etc, etc)-- the Castle is packed with th...
Chris led me to a dirt strip a friend of his has set up by his ranch near Taos. We just made a low pass and did not land. We landed at Taos and topped of our gas tanks and headed out for the last leg of the trip Belen.
...the partially exposed ruins of the indian village on top of the mesa. At the base of El Morro is l...as ornate carvings of early Spanish explorers dating back to the 1605.
...ed a zip tie to an oval piece of rubber I cut. The rubber is basically a was...the bolt and washer of the LED strobe itself. I cut the rubber slightly ova...ich I could put a hole through and zip tie to. The grey wire then exits towa...